Modelis ir erdve

Find all posts by doctormax. Only issue I have with this, is it shows to install this strip befoere you have rolled and glued the cylindrical fuselage section. I find the that gluing strips in place before rolling the fuselage section causes creases and wrinkles in the outer skin because of the glued tension between the inner and outer surfaces. Hello guys, STRK is completely right. The small inset diagram with the magnifying glass shows adding a strip of paper to the inside edge of each end of the fuselage section.

Uploader: Dujas
Date Added: 27 August 2017
File Size: 32.81 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 75864
Price: Free* [*Free Regsitration Required]





Originally Posted by strk I got a friend from Lithuania. The strip is placed 1mm from the edge to allow a 1mm thickness Former modwlis fit flush with the end of the tubular fuselage section. But theres something in that magnifying glass They must be glued in very precisely.

Then two foermers added, one at each end. I also attached translated page as was asked.

Modelis Ir Erdve - Papel3D

Originally Posted by rmks I've never seen any of this publisher's kits built, other than a car, so I look forward to this thread. Does it include a cockpit? The time now is Find all posts by airdave. The small inset diagram with the magnifying glass shows adding a strip of paper to the inside edge of each end erdv the fuselage section.

BB code is On. Send a private message to doctormax. I sent a mail to my friend. edrve

Find all posts by rmks Originally Posted by rmks Login to remove ads. Find all posts by Agnius.

Eurofighter Typhoon Modelis IR Erdve - nejinn.xyz

Send a private message to Agnius. Maybe he could help? Originally Posted by strk I sent a mail to my friend. My suggestion is, mark a line, at the 1mm inset, and glue in the stopper modelus after the fuselage has been rolled and glued into shape.

List of products by manufacturer Modelis ir Erdve

So, my result is: I've never seen any of this publisher's kits built, other than a car, so I look forward to this thread. Originally Posted by doctormax Hi a bit about the kit before get underway. Send a private message to rmks In the meantime, I tried to type some words into google. Do not be afraid to ask in case you have more questions Good luck! So i have taken the pages out of the kit by removing the staples two staples and cut a few parts for laminiation as i figure they are formers and need to be glued to 1mm card.

Only issue I have with this, is it shows to install this strip befoere you have rolled and glued the cylindrical fuselage section. I recommend to glue the formers frames on some heavier paper cardboard.

Find all posts by doctormax. But back to the kit card is fair thick stuff compared to others I have done in the past and a lot more than the gsm i try to use for builds. Originally Posted by doctormax. Resources saved on this page: Find all posts by strk.

I think going to need the knife pretty sharp for this.

1 Comment

  1. Kazahn

    I consider, that you commit an error. I can defend the position. Write to me in PM.

  2. Kelrajas

    I consider, that you are mistaken. I suggest it to discuss.

Leave a Reply

Your email address will not be published. Required fields are marked *

Page 1 of 2

Powered by WordPress & Theme by Anders Norén